News

Home / News (Page 2)

News

  • Types of Female Header Blocks

    If you want to connect multiple external components, you can use a Female header block to do so. Unlike the male version, this block features a single connector for each pin, making it much easier to attach/detach external components. The female header block is usually made of plastic and comes in a...

  • D-Sub Terminal Blocks

    Terminal blocks are available in different forms and sizes to accommodate different cable types and connectors. These blocks are designed for permanent and semi-permanent connections. They can accommodate wire sizes ranging from 16 awg to -7.5 awg, equivalent to 600 kcmil. Most terminal blocks come ...

  • Types Of PCB Connectors And Their Uses

    There are different types of PCB connectors and their uses on the board. The SWaP property of the connectors depends on the final application. A mobile phone connector must be smaller than a car connector. They are available in four primary layouts: wire-to-board, board-to-board, and cable-to-board....

  • Pluggable Terminal Block

    A Pluggable terminal block is an electrical connector that enables users to plug in and switch signal cables with ease. The innovative design of a Terminal Block eliminates the need for soldering and makes it possible for users to plug in and switch signals in a matter of minutes. Here are the benef...

  • DIP Switches Manufacturers

    DIP switches are a type of manual electric switch. They are typically packaged in standard dual in-line packages. They can refer to individual switches or the whole unit. Each DIP switch is labeled and numbered to identify its location. A DIP is one of the most popular types of electronic switches, ...

  • there are several things to consider about terminal blocks

    Terminal blocks are used to connect two or more circuits. They provide electrical grounding to reduce the risk of short circuits. Since connecting two or more circuits is a very time-consuming task, terminal blocks are a great solution. Some products are better suited for high-power and high-vibrati...

  • Advantage Of DIN 41612 Connector

    The DIN 41612 Connector is a two-piece backplane connector. This type of connector is used in rack-based telecommunication systems and many other applications. It is widely used in computing, medical, process control, and industrial automation. This type of connector has a 0.1-inch grid pitch and fe...

  • Reliability Screening Test for Preventing Failure of Terminal Blocks

    In order to ensure the quality and reliability of the wiring terminals and prevent the occurrence of the above-mentioned fatal failures, it is recommended to study and formulate corresponding screening technical requirements according to the technical conditions of the product, and carry out the fol...

  • How to understand the physical factor that the relative tensile force of the inductance guide pin of the terminal is lower?

    There are many types of terminal pins, such as PIN pins, four-point pins, etc. Compared with the terminal series products of electronics and automobiles, the relative tension of the inductive guide pins will be lower, and sometimes the tension will be insufficient for a long time. To know what is ca...

  • Comparison of the differences between IDE, SCSI and SATA hard disk interfaces:

    1. The working mode of the IDE requires the full participation of the CPU, and other operations cannot be performed when the CPU reads and writes data. This situation will naturally cause the system's response to be greatly slowed down in the multitasking operating system of Windows95/NT. The SCSI i...